Rain Bird PAR+ES Technical Information download pdf (Page 27)

PAR+ES Operation Manual 25

DISPLAY

CONTROL

PROGRAMMING CONTROLS OPERATING CONTROLS

STATION RUN TIMES

START TIMES

START DAYS

WATER BUDGET

WEEKDAY / CYCLE

CLOCK STATUS

SCHEDULE MONITOR

MULTI-MANUAL

SET CLOCK

SYSTEM INFORMATION

COPY STORE

COPY PASTE

PROGRAMMING CONTROLS OPERATING CONTROLS

STATION RUN TIMES

START TIMES

START DAYS

WATER BUDGET

WEEKDAY / CYCLE

CLOCK STATUS

SCHEDULE MONITOR

MULTI-MANUAL

SET CLOCK

SYSTEM INFORMATION

COPY STORE

COPY PASTE

CONTROL MODE

START / ADVANCE

DISPLAY

CONTROL

OFF MANUAL LOCAL MAXI

CANCEL / CLEAR

DISPLAY

CONTROL

Sensor Select

This function lets you select the status (ON or OFF)

and installation type (NC for Normally Closed or NO

for Normally Open) of any rain or moisture sensor

connected to your PAR+ES�

From the “Relay-Board Test” screen, press the

1.

SYSTEM INFORMATION button� The “Sensor

Select” screen appears� (If the display reads

“Relay-Board Test Found 1�2��” press the SYSTEM

INFORMATION button TWICE to access the

“Sensor Select” screen�)

Line 2 displays the sensor status (ON or OFF)�

2.

Press the UP / DOWN arrows to select the desired

status� If the sensor status is OFF (the default),

the controller will ignore all sensor input� Sensor

status ON means the controller will respond to

sensor input�

NOTE:

If the rain sensor activates, the

controller will cancel any schedule(s) in

progress , and the Clock Status screen will

ﬂash a “Sensor Active” message�

When sensor status is ON, line 2 will also display

3.

the sensor installation type (“NC” for normally

closed or “NO” for normally open)�

Press the RIGHT / LEFT arrows to move to the

4.

sensor type� Press the UP / DOWN arrows to select

the proper sensor installation type (NC or NO) for

your system�

Internal Self-Test

This function tests the controller’s internal memory,

hardware, and power-up display�

From the “Sensor Select” screen, press the SYSTEM

1.

INFORMATION button to display the “Self Test”

screen�

The display reads “Push ‘START’ to begin�” Press

2.

the START / ADVANCE button to begin the self-

test� The controller will automatically run through

the test procedure and show any failures in the

display� Then the controller will return to Clock

Status mode�

Note any failure message and contact your Rain

Bird distributor for assistance�

Sensor Select

Stat: OFF

Relay-Board Test

...Push Start...

Sensor Select

Stat: ON Type:NC

635777 Rev B (PAR+ES operations manual (1of2 ENG)) source.indd 25 12/20/2007 8:40:21 AM

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Comments to this Manuals

No comments

Rain Bird PAR+ES Technical Information Page 27

Comments to this Manuals