Set Satellite Group ID
From the “Sensor Select” screen, press the SYSTEM
1.
INFORMATION button� The “Set Satellite Group
ID” screen appears�
Press the UP / DOWN arrow buttons to set the
2.
satellite group ID number from 0 (the default) to
8�
Production Tests
The Production Test function lets you run six special
diagnostic tests that can help identify problems
with the controller’s keypad, LCD display, and other
functions�
NOTE:
!
Production tests are designed to
facilitate controller production and field
testing and are not used for day-to-day
operation� It is not normally necessary to
perform these tests unless you experience a
problem with the controller�
To enter Production Test mode, access the “Self
1.
Test” screen (as described on page 21) and
press the START / ADVANCE button to begin
the test� Then immediately press the SYSTEM
INFORMATION button�
The “Key Pad Test” screen appears� (To cycle
2.
through the production tests to reach another
test, press the SYSTEM INFORMATION button
additional times)�
After entering a production test, press the START
3.
/ ADVANCE button to activate that test�
CAUTION:
F
The only safe way to exit
Production Test mode and retain all
programmed schedules is to “Warm Start”
the controller (as shown on page 26)� DO
NOT perform a “Cold Start” (page 27) unless
you want to erase all programmed schedule
information and reset all controller functions
to factory defaults�
SET SATELLITE
Group ID = 0
Key Pad Test
...Push Start...
Key Pad Test
...Push Start...
Self Test, Push
“START” to begin
1
2
2
1
3
Comments to this Manuals